hej ccd medlemmer
er der nogen der ved hvordan man måler sims ud efter et rammeløft
der sad godt nok nogle men jeg tror ikke at der er system i det
tonny
p.s hvordan indsætter man et billede
corvette 66 cap
Re: corvette 66 cap
Da jeg rammeløftede brugte jeg denne metode som doctor rebuild beskriver her, brug shims hvis karrossen ikke rør afstandstykkerne.
After replacing a 53-82 Corvette body on the frame using the authentic
type cushions there will still be a gap between some of the 8 to 10
frame attachment points. At these gaps you slide in one or more shim
to remove the space. All this is easily determined by using an
authentic design cushion and shim. I have taken apart most every year,
but 84 up and virtually every one is shimmed different. Simply stated
there was a large variation between body and frame tolerances as these
Corvettes are nothing more than mass produced automobiles, not space
shuttles.
After replacing a 53-82 Corvette body on the frame using the authentic
type cushions there will still be a gap between some of the 8 to 10
frame attachment points. At these gaps you slide in one or more shim
to remove the space. All this is easily determined by using an
authentic design cushion and shim. I have taken apart most every year,
but 84 up and virtually every one is shimmed different. Simply stated
there was a large variation between body and frame tolerances as these
Corvettes are nothing more than mass produced automobiles, not space
shuttles.
Hvem er online
Brugere der læser dette forum: Ingen og 6 gæster